Akasa 3-Pin Addressable RGB LED Splitter and Extension Cable | 1-to-3 aRGB LED Splitter | 3-Pin Connector | 1 Female to 3 Male | 50cm | AK-CBLD07-50BK

Does what you need splits 1 into 3. I needed it as my motherboard only has 2 headers. Moths RGB daisy chains but when I upgraded my water cooled GPU to one that needed a water block on the front and the back... Great job Nvidia 🤯 EK don't join the RGB on the front and back if the card but have 2 separate plugs with no pass through. Proper first world problem but I needed 2 plug for my other RGB stuff and two plugs for the new GPU water block. Thus this product fit the bill. Wasn't the absolute cheapest but it arrived quickly.

Well to be fair I've already have one but needed a second one rather quickly these are built well good thick cables just plug it in 'n' go no hassles.

Ordered 2 of these and they arrived next morning so no complaints there...The cables themselves seem to be of good quality and well made.I wish I could say the same about the pins... They are very weak and flimsy and they don't hold into the fan socket very well. I found out to my cost when they came adrift while moving my PC around...A word to the manufacturer / supplier here...You make a decent product here but spoil it by the exclusion of a simple (plastic) clip on piece to hold both the plug and socket together so they are held firm and cannot just come apart when joined...I would've given 5 stars but for this otherwise.... BUT, that said, I blame the motherboard manufacturers as well for putting such crappy, thin pins on their boards for the A-RGB headers...

The media could not be loaded. So easy my daughter installed it.Bought for 3 Aerocool Argb fans for myAsus Rog Strix B450F Gaming II motherboard.Board only has 1x 3 pin addressable Red/green/blue Aura Sync Header at the bottom of the atx motherboard so bought this to link all 3 fans together for the Aura Sync lighting.Works a treat.

They work well and as expected

Good

DOA dont work supposed to be a good fit on the Motherboard header but its so slack it would require some form of adhesive or tape to keep it in position ,i have the 2 way splitter from the same company for my other pc and its great but this 3 way one is really badly made sending it back

Does the job needed, though the connection had to be taped to prevent popping off. This is by no means Akasa's fault, but rather the standard (3-pin plug) of all addressable RGB cable connection is poor in general. If you need a splitter, yes this is fine.