Manual Performance Shifter Stop Gap Removal Shift Stop Red Anodized for Subaru 2015 WRX/10-14 Legacy/Outback/14+ Forester

Works as intended. Saved me big money!

Installing the stopper is a cinch. Just a little fiddly to adjust right. It works great. I had a shop install the bushing for me after watching videos. It's not super hard, but you gotta get up under the car. (And you need grease) With both parts installed, it feels amazing. 1&2 feel like 3&4 now. Everything is tight.

Works perfect for my 2017 WRX. Installation instructions simple to read. No slop what so ever while in first and second. Quick fix and fraction of the cost of Perrin and others. Would highly recommend nobody gonna see the name after installing on shift boot if thats what your worried about. I wasnt. I was more worried about the metal and the machining of the product. Id say just about perfect. Money saved will go into buying that damn fuse box coin holder. LoL

This reverse lockout is great, it’s cheap and only took 10 minutes to install. The hardest part was getting the shift boot off for the first time but it’s really not that hard. My only complaint is that at the highest up point when installed, it is just a little too short, and when u knock it over into first or shift too hard into second, it kicks the reverse lockup up. Now this isn’t a bad thing but the reverse lockout kicking up means the shift stop’s purpose is defeated. I Only complain because the “name brand” versions, such as Perrin, don’t have this issue. I resolved it by putting 2 washers on each side underneath the new shirt stop but above the OEM one that’s in there already and it seems to have done the trick. All in with washers and time it was still a third or fourth of the price compared to main stream companies so this is worth it. Thank you!

I have a 2020 WRX Limited with the factory shifter.This shifter stop is perfect. Works just like it should and it’s easy to install in just a few minutes. As others had mentioned, the screws that come with it are too long, so you’ll need to go to Lowe’s or Home Depot to get a couple of M6-1.0x16mm (they cost under $2). You can get ones that match with the same hex head as the ones that come with this shifter stop.Haven’t installed the bushing yet, but will do that soon and update the review if necessary.