[Gulfcoast Robotics] 3D Printing Build Surface Heated Bed Platform 3M Sticker 220x220mm for Maker Select Duplicator I3 Anet A8 RepRap Prusa i3 (Pack of 3)

These are amazing for PLA and other non-heated applications. However, if you heat your bed to 100C for ABS, the sheet may delaminate from the adhesive. I have been able to print at 80C with ABS, but I used a 4mm brim.You will also need to get your z height just right. If you smoosh your filament into this, it will be very difficult to remove and could damage the sheet. Start high and work your way down with z adjustments. Once the height is right, you will be golden for bed adhesion. I have printed PLA, Wood PLA, PETG, TPU, and ABS on this without using any glue stick/hair spray or anything else. The only reason I rated 4 stars is because of the delamination at higher print temps.

These worked great on my Anet A8's glass hotbed. Everything sticks really well now (maybe a little too well at times) and it keeps my glass hotbed from being damaged trying to scrape things off. Now, be warned that if your nozzle is too close to the bed it will fuse the plastic with this build platform (I use PETG) and larger prints can be a bit tricky to remove. One other little nag I have is that it's difficult to remove from the bed when you want to replace it and it leaves a lot of residue. Overall I'm happy with it though.

It's funny because it does exactly what I wanted and I hate it for it. It works great, but I struggle to get prints off sometimes because it adheres so well to the print. I was also trying to line up the build area and it took like 4 times to peel and stick the sheet on.

I have had NO adhesion issues with these pads. I've printed in PLA and PETG and they stick.....maybe a little too much. Highly recommend.

Is very easy to use... but... very hard to remove prints.

Works great on my Anycubic I3 Mega

So much better than using tape!