PartsamT10 194 168 LED Dash Instrument Light Bulbs White with Twist Lock Socket, Super Bright T10 Instrument Panel Gauge Cluster Dashboard Lights Bulbs 12V 6-2835-SMD LED Chipset, 10Pcs/Set

Works great, no flickeringUsed for cluster and shifter lightHopefully has a li g life span

LED's were easy to install. I checked them first for polarity with a 12 volt battery and some small speaker wire I had. Then I marked the positive wire on each bulb with a red marker so I'd know what's positive. Then I installed them in the dash all in one direction, except the one bulb behind the oil pressure gauge is the opposite direction of the other 5 for some reason. Just pay attention because if you turn them fully locked in they wont make contact with the soldier ribbon on the printed circuit board and they wont work. That was simple to pay attention to. They work fine and are nice and bright. I'd been thinking about doing this for years, but didn't know if I'd like the look, but I definitely do and glad I finally spent that $12. I also changed the 2 floor light bulbs under the dash and it looks so much better than the ugly yellow old fashioned look of the old bulbs. It was worth it 100%

I had the cluster out to fix a burnt out check engine light and decided to buy these. Absolutely impressed by them and installed easily but make sure you don’t bolt the cluster back in until you have all the lights correctly installed. If they don’t work at first, just flip them 180. Well worth the money and make our 1994 Sierra much nicer in the cab!

Nice and bright my only gripe is now the speedometer is not as bright so I will be changing the smaller bulbs out to see if that helps

My original LED lights on my gauge cluster finally startrd to give out. These were a direct fit. They look great, plus they work with the dim switch.

My cluster was half dead. But now is nice and bright. Make sure you test then before you put the cluster back. I have to turn 2 light around cause they where not on. 2001 toyota camry CE

I ordered these and when they arrived I found that what they send you is bags of parts and you are expected to put them together. What a p.i.t.a.. Then I found that the sockets / mounts that they sent don't actually fit the hole where the bulb goes. Also, the finished assembled part is about 1.5mm longer than the old OEM part and it's doubtful it will fit. I'm just sending the whole mess back to them and finding already assembled OEM style bulbs.

The lights were a little tricky to get to operate but now work fantastic. I used some of the new twist locks to get the bulbs to work and had to insert and remove the bulbs a couple of times in the new and even one of the old twist locks to get the lights to work right. It was some trial and error but finally got all main backlight bulbs to work before putting everything back together. I recommend these bulbs and the new twist locks that came with it. Tip: You may need to wipe or clean the copper contact on the back of the circuit board with smidge of alcohol before putting the bulb into the circuit board to get a good solid contact. Best of wishes! 🙃